On June 20, the Office of the Comptroller of the Currency (“OCC”) issued interim final rules (including both the interim final rule and the preamble, the “Lending Limit Release”) to implement Section 610 of the Dodd-Frank Wall Street Reform and Consumer Protection Act (“Dodd-Frank”). Section 610 expands the statutory definition of “loans and extensions of credit” in the lending limit provisions of the National Bank Act1 and Home Owners’ Loan Act2 to include the credit exposure from repurchase and reverse repurchase transactions and securities lending and borrowing transactions (collectively, “securities financing transactions”) and derivative transactions.3 The Lending Limit Release sets out the procedures and methodologies for calculating the credit exposure for these newly covered transactions. The Lending Limit Release also establishes a single set of lending limit rules applicable to both national banks and federal and state-chartered savings associations. The lending limit rules are effective July 21, 2012, with an exemption until January 1, 2013 for credit exposures from derivatives and securities financing transactions.
The Lending Limit Release is the second agency rulemaking to define “credit exposure” arising from derivative and securities financing transactions. Previously the Board of Governors of the Federal Reserve System (“Federal Reserve”) proposed rules to implement the single-counterparty credit limit in Section 165(e) of Dodd-Frank (“Proposed SCCL Rules”).4 The Proposed SCCL Rules apply to bank holding companies with $50 billion or more in total consolidated assets and nonbank financial companies that have been designated as systemic by the Financial Stability Oversight Council. The OCC’s approach to measuring credit exposure in the Lending Limit Release is less burdensome and provides significantly more flexibility than that in the Proposed SCCL Rules, including by permitting banks to measure credit exposures using supervisor-approved internal models and treating credit exposures that come to exceed the lending limit after inception of the transaction as nonconforming transactions that a bank must bring back into compliance with the lending limit rather than as automatic violations of the limit. In addition, for each type of transaction, the Lending Limit Release includes an alternative streamlined approach to measuring credit exposure that allows a bank to lock in the amount of the credit exposure at inception of the exposure.
IMPLEMENTATION OF SECTION 610
The lending limits applicable to national banks and federal and state chartered savings associations (collectively, “banks”) generally limit the total loans and extensions of credit from a bank to a person to 15% of the unimpaired capital and unimpaired surplus (“capital”) of the bank, with an increase of 10% of capital available if the exposure over 15% of capital is fully secured by readily marketable collateral. As a result of Dodd-Frank, as of July 21, 2012, a bank must include credit exposures from derivative and securities financing transactions within the applicable limit. In the Lending Limit Release, the OCC states that it reviewed comments received by other agencies in response to rulemakings to implement provisions of Dodd-Frank that raise similar issues, including comments on the Proposed SCCL Rules. Indeed, the OCC’s approach to defining “credit exposure” for this purpose responds to many of the concerns expressed by commenters on the Proposed SCCL Rules.5 In particular, the OCC has adopted an approach that provides banks with important flexibility in calculating compliance with the lending limit rules rather than imposing a one-size-fits-all approach. By permitting banks to use supervisor-approved internal models, the Lending Limit Release allows banks that have already developed such models to continue to use these more risk-sensitive methods of measuring credit exposure and rely on the systems they currently use for credit risk management purposes to monitor compliance with the lending limit rules as well.
Key elements of the Lending Limit Release are a significant departure from the Proposed SCCL Rules. The accompanying chart provides greater detail regarding the calculation methodologies discussed below, as well as a comparison to comparable provisions in the Proposed SCCL Rules.
- Internal models. In one of the most significant differences between the Lending Limit Release and the Proposed SCCL Rules, a bank may use internal models developed to comply with the banking agencies’ Basel II capital guidelines for advanced approaches banks or another internal model that has been approved by the bank’s primary federal supervisor for establishing the amount of credit exposures under the lending limits. Although the Lending Limit Release provides that the use of an internal model is optional, the appropriate federal banking agency may require that a bank use the internal model method rather than one of the other alternatives discussed below if necessary for safety and soundness purposes. In order to measure credit exposure from credit derivatives under the internal model, the bank must have a margining agreement in place that requires daily posting of variation margin to fully collateralize the bank’s net counterparty exposure in excess of $1 million under the agreement.
- Derivatives transactions. The alternatives to the models approach for calculating credit exposures arising from derivatives transactions include (i) a calculation methodology based only on the estimated potential future exposure (“PFE”) of a transaction, which allows a bank to lock in the amount of the exposure at inception (the “conversion factor matrix approach”) and (ii) a calculation methodology that is performed on an ongoing basis and includes the current mark-to-market value of the transaction plus an additional amount (to account for PFE) that decreases as the time to maturity elapses (the “remaining maturity approach”). The conversion factor matrix approach has the benefit of simplicity and certainty because the exposure amount for purposes of the lending limit never changes despite fluctuations in market value, while the remaining maturity approach would allow a bank more room under the lending limit to the extent the mark-to-market value of the transaction decreases over time (but less room if the mark-to-market value increases). Neither approach, however, takes into account netting or collateral and, therefore, may be less workable for a bank with a substantial derivatives portfolio. The appropriate federal banking agency may require that a bank use the internal model method or remaining maturity method if necessary for safety and soundness purposes.6
- Credit derivatives. Similar to the Proposed SCCL Rules, when a bank sells protection on a reference asset in the form of a credit derivative, it must treat the notional protection sold as an exposure to the reference asset. If that same bank purchases a credit derivative that meets certain eligibility criteria on the same reference asset, it may reduce the amount of its exposure to the reference asset. Unlike the Proposed SCCL Rules, a bank may use an eligible credit derivative only to reduce its exposure to a reference asset on which it has sold credit protection rather than to reduce exposures on other transactions (such as a loan or debt security), and the OCC requests comment on whether this is appropriate. If a bank purchases credit derivatives from a counterparty, it must include the net notional value of the protection purchased from that counterparty on all reference entities.
- Securities financing transactions. The alternative to the models approach for calculating credit exposure arising from securities financing transactions involves measuring exposure only at the inception of the transaction. In general, the methodologies for calculating credit exposure for securities financing transactions are meant to capture either the net current credit exposure of the transaction or, where the bank will be exposed to the fluctuations in the value of a security as part of the transaction, to capture that risk through the application of a market volatility haircut, using the standard supervisory market price volatility haircuts in the general risk-based capital rules. The Lending Limit Release also carries forward the existing exclusion in the lending limit rules from the definition of “loan and extension of credit” for reverse repurchase transactions where the bank purchases Type I securities (generally, certain government securities) as an exemption and applies the exemption to all securities financing transactions involving Type I securities.
- Nonconforming transactions. Under the OCC’s current lending limit rules, a loan or extension of credit to a borrower that complied with the lending limit at inception and subsequently exceeds the lending limit for certain enumerated reasons, such as that the bank’s capital has declined, is considered nonconforming and must be brought into compliance in accordance with the requirements of the rule. Under the Lending Limit Release, if a credit exposure arising from a derivative or securities financing transaction that is measured under the internal model method exceeds the lending limit after inception of the transaction, it also will be treated as nonconforming. A bank must use reasonable efforts to bring such nonconforming transactions into compliance with the lending limit, subject to safety and soundness considerations, but no timeframe is specified. Although the credit exposure of a derivative transaction measured under the remaining maturity approach also may fluctuate over time and, therefore, may exceed the lending limit after inception, such a lending limit excess is not included in the list of nonconforming transactions. While it may not be intentional, it appears, therefore, that credit exposures to derivative transactions measured under the remaining maturity approach could automatically trigger a violation of the lending limit rules if they exceed the lending limits after inception (unless the excess is attributable to a factor that would fit under another prong of the definition of nonconforming transaction, such as a decline in the bank’s capital). Under the Proposed SCCL Rules, exceeding the applicable limit in such cases could be an immediate violation, which means that a company subject to the limit may need to maintain a significant buffer at all times to avoid a violation.
- Intraday exposures. Similar to the Proposed SCCL Rules, intraday exposures arising from derivative or securities financing transactions would be exempt from the lending limit.
- Contingent exposure to a derivative clearing house. In the Lending Limit Release, the OCC requests comment on whether a bank’s contingent obligation under derivative clearinghouse rules to advance funds to a guaranty fund should be subject to the lending limits and, if so, how it should be measured. Such exposures would be covered under the Proposed SCCL Rules.
The Lending Limit Release offers banks a more flexible approach to measuring credit exposure from derivatives and securities financing transactions than the approach in the Proposed SCCL Rules to measuring the same credit exposures. Although the Lending Limit Release seeks to ease the compliance burden on banks subject to the rules, the different approaches to measuring the same credit exposures taken by the OCC and the Federal Reserve may result in a greater overall compliance burden and other complications for banks that are subject to both regimes. Furthermore, in the absence of a fundamental change in approach by the Federal Reserve in its final SCCL rules, banks that are subject to the Lending Limit Release and the single-counterparty credit limit could effectively have a reduced lending limit at the bank because the same exposures would have to be measured under a less risk-sensitive approach under the Proposed SCCL Rules.
Click here to see the PROPOSED SINGLE COUNTERPARTY CREDIT LIMIT AND LENDING LIMIT RELEASE COMPARISON CHART.